# uncomment to increase signal to HDMI, if you have interference, blanking, or # uncomment to force a HDMI mode rather than DVI. # uncomment to force a specific HDMI mode (this will force VGA) # uncomment if hdmi display is not detected and composite is being output By default it will be display's size minus # goes off screen, and negative if there is too much border # uncomment the following to adjust overscan. # and your display can output without overscan # uncomment this if your display has a black border of unused pixels visible # uncomment if you get no picture on HDMI for a default "safe" mode # Some settings may impact device functionality. Perhaps you aren't given any resolution options because you have already forced a resolution - have you tried editing config.txt to set the video mode back to default?įor reference, here's my /boot/config.txt file: # For more options and information see I did this all in headless mode via a VNC session on a fresh Raspian Stretch install, using VNCViewer 6.0.1 on Windows. On the system tab, click the Set Resolution.Open the Raspberry Pi configuration application ('Start' > Preferences > Raspberry Pi Configuration).I followed the instructions on RealVNCs troubleshooting page.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |